2002 Ganesh GT-1640 Manual Lathe

GANESH GT-16 SERIES

Capacity & Dimensions-
Swing over Bed 16” 410mm
Center height 8-1/16” 205mm
Swing over Cross Slide 9-7/16” 240mm
Swing thru Gap 23-7/16” 595mm
Length of Gap in front of face plate, D1-6 / A1-6 6-1/8” / 6-7/8” 155mm / 175mm optional
Bed casting width / bed casting height 11-13/16” / 8-1/16” 300mm / 205mm

Spindle-
Spindle Motor Horsepower 7.5 HP 7.5 HP
+ 540 1600 325 1000 700 2000
- 55 160 30 95 70 200
Spindle speeds – 12-speeds 30 – 2000 rpm)
(+ = High & - = Low)

Spindle Bore 2-1/16” 52mm
Spindle Nose D1-6 A1-6 optional
Spindle taper in spindle nose MT-6 Morse Taper #6

Carriage -
Cross slide travel / Cross slide width 9” / 7-3/32” 230mm / 180mm
Cross slide lead screw pitch .200”/rev.
Cross slide resolution per division 0.001” (on diameters)
Carriage lead screw diameter / pitch 1-1/4” / 4 TPI 32mm / 6mm pitch
Feed rod dimensions 7/8” hexagon 23mm hexagon

Compound-
Compound top slide travel / Compound width 4-3/4” / 4-11/32” 120mm / 110mm
Cutting tool height maximum 1.0” x 1.0” 25mm x 25mm

Tailstock- Engraved with inch / metric quill graduations
Quill diameter 2-1/8” 54mm
Quill stroke 4-3/4” 120mm
Quill taper MT-4 Morse Taper #4
Quill tang drive and drift-slot for tailstock included
Tailstock body set-over adjustment ± ½” ± 13mm

Thread Cutting-
Thread cutting range – 40 inch pitches 2 – 56 TPI
Thread cutting range – 53 metric pitches 0.4 – 14mm
Thread cutting range – 32 diametral pitches 4 – 32 D.P. Optional
Thread cutting range – 44 module pitches 0.4 – 7 M.P. Optional

Feeds- (with clutched feed shaft for safety)
Feeds – longitudinal - 40 feeds 0.0012” – 0.0252”/rev. 0.032mm – 0.898mm/rev.
Feeds – cross - 40 feeds 0.0006” – 0.0126”/rev. 0.016mm – 0.449mm/rev.
Feed stop control shaft 4-adjustable automatic feed stops to disengage the longitudinal feed

Power-

Coolant pump motor 220vac, 1/8-HP, 3-Phase
Power requirements 220 vac, 7.5-HP, 3-Phase @ 35-amps