Refurbished Barnes Vertical Single Spindle Hone, Model #3010-65

Great shape! Rebuilt in 2021 with $39k in new Fixture Assembly, Drive Shaft Assembly, Hone Tool Assembly and Filtration System. Available immediately. Louis Allis adjustable frequency installed when the Louis Allis was installed, control panel was completely re-wired at that time too. FIXTURE ASSY: Fixture assembly to locate and contain Housing Subassembly, p.n. 3032921-201. Includes bottom plate, top plate, housing, rods, top ring and bushing. Assembled complete. Fixture assembly will be designed to mount to machine fixed table DRIVE SHAFT ASSY: Drive shaft assembly to connect hone tool assembly to machine spindle. Includes two (2) driver ends, tube assembly and two (2) universal block assemblies. Assembled complete. MODEL HF HONE TOOL ASSY: or 8.977”/8.974” Bore Diameter Model HF hone tool assembly complete with tool body, cone, expansion plates, pull pins, push rod, stone holders, thrust clamps, guides, garter springs, compression spring and set of rough and finish vitrified honing stone assemblies. Assembled complete FILTRATION SYSTEM: Model DTE-100 coolant filtration system arranged with strainer bed, coolant (79 gallons) and slurry tank (12 gallons) with drain connection, 23” inlet height, 25 micron clarity filter fabric, low level fluid indication and electrical equipment including CE box with switches, contactors and relays for coolant pump. Flow rate with “neat” honing oil is 13 GPM. Includes two (2) fifty-five (55) gallon drums of honing oil specific to honing aluminum